① Electric purifier: Use TGY-1 electric purifier, connect the piston rod to the negative pole of the power supply (positive connection), energize, voltage 10~14V, time 10~30s. The purpose of electric cleaning is to remove the surface oil film. After cleaning, use tap water to rinse away the remaining liquid on the surface of the piston rod.
②Activation: Use THY-5 activation fluid, connect the piston rod to the positive pole of the power supply (reverse connection), energize, voltage 12~15V, time 10~30s; connect the piston rod to the negative pole of the power supply (positive connection), energize, voltage 10~12V, The time is 10 to 20 seconds. At this time, the surface of the occlusion rod turns silver gray. The purpose of activation is to remove the oxide film on the surface of the piston rod.
③ Brush plating bottom layer: special nickel plating (TDY101), wipe without electricity for 3 to 5 seconds. The piston rod is connected to the negative pole (positive connection) of the power supply, and the voltage is 15~18V. The relative movement speed of cathode and anode is 10~15m/min. Coating thickness δ=2μm.
④ Brush plating working layer: Use rapid nickel (TDY102) and wipe without electricity for 3 to 5 seconds. The piston rod is connected to the positive pole of the power supply (reverse connection), and the voltage is 15V. The relative movement speed of cathode and anode is 12~15m/min to eliminate stress and improve strength. After the damaged area is filled, polish the surface with metallographic sandpaper and oilstone, and use a sample for testing.
⑤Final working layer of brush plating: The piston rod is connected to the positive pole of the power supply (reverse connection), energized, and the voltage is 15V. The relative movement speed of cathode and anode is 12~15m/min. Chrome-gold plating, coating thickness δ=2~5μm.
⑥Polishing: Use a polishing wheel to polish the brush plating area so that the surface roughness reaches Ra=0.4μm and the dimensional accuracy meets the requirements.
Details of the brush plating repair process for cylinder barrel, piston and piston rod
Apr 03, 2024
Send Inquiry
Categories
Contact Us
- Tel: +8613861835411
- Email: andsonying@163.com
- Email: andsonying@wxboton.com
- Add: 2 Luxi Road, Yangshan Industrial Zone, Huishan District, Wuxi City, Jiangsu, China






