Home > Knowledge > Content

High Frequency Heat Treatment and Surface Hardness Requirements for Linear Optical Axis

Dec 27, 2022

The linear light shaft has the guiding function of sliding bearings during use, and can implement linear motion products during use. The necessary conditions for these linear motion systems are simple design and execution capabilities, and low maintenance costs for the entire equipment. , and use strictly selected durable materials.

The high-frequency heat treatment of the linear optical shaft adopts its accurate outer diameter, roundness, straightness and surface treatment. The common shafts are crankshaft, straight shaft and flexible shaft. The rotating shaft can bear both bending moment and Bearing torque is a common shaft in machinery, such as shafts in various reducers.

The mandrel of the linear light Shaft is used to support the rotating parts and only bears the bending moment without transmitting the torque. Some mandrels rotate, such as the shaft of the railway vehicle, etc.; some mandrels do not rotate, such as the shaft supporting the pulley, etc.; the transmission shaft is mainly It is used to transmit torque without bearing bending moment, such as the long optical axis in the moving mechanism of the crane, the drive shaft of the car, etc.

The material of the linear light shaft is mainly carbon steel and alloy steel. It can also be used in ductile iron and alloy cast iron. In general, the working ability of the shaft generally depends on the strength and stiffness. When the speed is high, it is still Depends on vibration stability.

Ordinary linear light Shaft has high requirements on the surface hardness of ordinary linear optical axis because the ordinary linear optical axis is in contact with the linear bearing point, so the material and heat treatment method are very important. The material is equivalent to the national standard gcr15. Hardness: hrc60±2; hardened layer depth: 0.8-3mm; surface roughness: ra0.10m-ra0.35m; straightness: below 70um/1000mm.


Send Inquiry
Contact Us