In order to ensure the machining accuracy, when turning the piston rod, the rough turning and finishing turning should be separated. In addition, both rough and finish cars use the tool holder to reduce the deformation of the workpiece during processing. At the same time, when processing the threads at both ends, you should also remember to use the steady rest.
When grinding the outer surface of the piston rod, the workpiece will be easily deformed by the tool and elastic, thus affecting the precision of the piston rod. Therefore, the center hole should be repaired during processing to ensure the cleanliness of the center hole and the appropriate degree of tightness between the center hole and good lubrication.
When thread processing, if the piston rod has a relatively large thread processing tolerance and poor centering ability, and the coaxiality of the assembly cannot be guaranteed, when we assemble the guide sleeve, it should be positioned by its outer sealing surface. If The length of this positioning surface is less than the matching length of the thread, so it should be screwed into the fit during assembly, and then enter the fit from the positioning surface.






