Home > Knowledge > Content

Insufficient piston rod pressure (2)

Aug 23, 2022

There is oil in the cylinder, but no pressure in the piston rod.

(1) The pump or relief valve is faulty. If the piston rod has a certain pressure, the relief valve can be adjusted, and in the case of supercharging, the oil output of the pump is significantly reduced. At the same time, the pressure value does not reach the required value, which may be caused by the increase of the clearance after the pump is worn.

To this end, the volumetric efficiency of the pump can be detected to determine whether the pump can continue to operate. If the wear is too serious, it should be repaired or replaced in time.

(2) Serious internal leakage.

Add a shut-off valve to the open oil line connecting the cylinder block and the fuel tank, close the valve, and then install a pressure gauge to detect the pressure rise. When the pressure rises to the supply pressure, it can be confirmed that there is a leak inside the cylinder block. Internal leakage is usually caused by loose piston nut or plunger, damaged bolt necks, substandard bolt tightening, and bolt shearing, resulting in loose piston and piston rod.

www.rodandtubechina.com


Send Inquiry
Contact Us