Home > Knowledge > Content

How to eliminate the blocking phenomenon of hydraulic cylinder

Oct 05, 2022

In some cases, failure of hydraulic cylinder action may be encountered. The so-called action failure, the key point is that after the action command is issued, the hydraulic cylinder cannot act immediately, and the action must be transmitted after a certain period of time, or sometimes it can move and then stop, showing that the operation is very irregular. Why does this happen?

Depending on the situation, there may be many reasons for this. First, there may be gas inside the hydraulic cylinder. The removal method is to exhaust according to the exhaust valve. Check whether there is inhaled gas at the sealing ring at the position where the hydraulic cylinder moves repeatedly, and if so, replace the sealing ring. Secondly, there are irregularities in the operation of the hydraulic pump, the pump rotation is hindered or there is a slight seizure. Removal method: According to the type of hydraulic pump and the cause of its failure, solve it separately.

The third point is that when some hydraulic cylinders with buffer devices are started in the reverse direction, the piston may be terminated for a short time or reversed. In this case, the solution to be taken is: the orifice of the one-way valve is too small, so that the amount of oil entering the buffer chamber is too small, or even a vacuum occurs, so the above faults will occur at the moment when the buffer plunger leaves the end cover Phenomenon. In this regard, the orifice of the one-way valve should be increased.

In addition, it may also be because in practical applications, the speed of the piston movement is relatively fast, causing the steel ball of the one-way valve to follow the oil flow, which in turn causes the valve hole to be blocked, resulting in irregular movements of the hydraulic cylinder. Clearing method: Replace the steel ball with a poppet valve or valve core with a guide shoulder.

In addition, it may also be because the inner layer of the rubber hose is detached due to long-term use, resulting in the blockage of the oil passage sometimes, which will cause the hydraulic cylinder to act irregularly. At this time, the rubber hose must be replaced in time.

www.rodandtubechina.com


Send Inquiry
Contact Us